DODGE RAM TRUCKS & RAM CHARGER

Dodge used different types of drive shafts stock from the factory. Please see below for examples and how to measure.

FRONT DRIVE SHAFTS

Type A drive shaft with standard spline
Figure 1: Double Cardan Yoke at T-Case. Type A drive shaft with standard spline $269.00 with X spline, $299.00 using 1310 series u-joints. Measure length as per Figure 3.
Type A drive shaft with flange
Figure 2: Double Cardan Flanged at T-Case. Type A drive shaft with flange at C.V. end with standard spline $319.00 with X spline, $349.00 using 1310 series u-joints. Measure length as per Figure 4.

Measure for Length and U-Joint Size

Fixed yoke to fixed yoke
Figure 3: Fixed yoke to fixed yoke
Flanged yoke to fixed yoke
Figure 4: Flanged yoke to fixed yoke
U-Joint size
Figure 5: U-Joint size
Spline/Slip Yoke Differences
Figure 6: Spline/Slip Yoke Differences

Newer & 1 Ton Front Drive Shafts (with double cardan and flanged both ends)

Double Cardan Flanged both ends newer  & 1 ton front drive shafts
Figure 7: Double Cardan Flanged both ends newer & 1 ton front drive shafts. Starting at $479.00
Flanged yoke to fixed yoke
Figure 8: Measure length for flanged yoke to flanged yoke
Flange measurements
Figure 9: If the differential flange is not the serrated type, we will need to know flange A, B, C1 & C2 dimensions.

Type B Front Drive Shaft

Figure 10: Starting at $219.00 on 2 tube using 1310 series u-joints. Please call with your dimensions for more detailed pricing.
Fixed yoke to fixed yoke
Figure 11: Measure length of fixed yoke to fixed yoke
U-Joint size
Figure 12: U-Joint size

DODGE 1500 Front Type AC Drive Shaft

Stock drive shaft
Figure 13: Stock drive shaft
Replacement Drive shaft
Figure 14: Replacement Drive shaft for newer tons. Starting at $389.00
Reverse slip to flanged yoke
Figure 15: Measure length  for reverse slip to flanged yoke
Flange measurements
Figure 16: For the Flange we will need to know the A, B, C1 & C2 dimensions.

Rear Drive Shaft

Please note we cannot build drive shafts longer than 75 also, we do not build or balance 2 Piece type drive shafts with the carrier bearing.

Please follow our measuring guide so the correct drive shaft can be built.
click here Download entire detailed PDF Measuring Guideclick here

Dodge used many different types of drive shafts stock from the factory over the years.

Type B shaft
Figure 17: Type B shaft
Type C shaft
Figure 18: Type C shaft
Length measurement
Figure 19: Length measurement
U-Joint size
Figure 20: U-Joint size
Flange measurements
Figure 21: For the Flange we will need to know the A, B, C1 & C2 dimensions.
CV Drive Shaft
Figure 22: CV Drive Shaft
Conventional two joint drive shaft
Figure 23: Conventional two joint drive shaft

Note: Most drive shafts shown in photos are polished and clear coated, this finish adds $25 the cost. We only recommend the polish & clear coat for show vehicles or very dry climates.
Free Shipping - click here for more information
Questions? Give us a
call!

| Tom Wood's Custom Drive Shafts |
Copyright © 1999-2017

Disclaimer
We reserve the right to change prices, or not sell an item, due to error in pricing.

[HOME] Tom Wood's Custom Drive Shaft's [HOME]