SUZUKI SAMURI

FRONT and REAR

The drive shafts we build will use 1310 series u-joint rather than the small stock u-joint. Suzuki used 2 different flange patterns please verify which flange pattern you have as well as measure for length.

Flange measurements
Figure 1: Measure for Length

Please measure the C1 and C2 Dimensions for the T-Case and Differential ends.

Flange measurements
Figure 2: Flange measurements

Please measure the C1 and C2 Dimensions for the T-Case and Differential ends.

Flange measurement A, B and C
Figure 3: Flange measurement A, B and C

Type B Drive shaft built with Standard Spline is $269.00 built with X Spline is $299.00.

Type B shaft
Figure 4: Type B shaft

Type A Drive shaft built with Standard Spline is $379.00, built with X Spline is $399.00

Type A shaft
Figure 5: Type A shaft
Spline/Slip Yoke Differences
Figure 6: Spline/Slip Yoke Differences

Make sure you have the proper geometry for the drive shaft you are using.

Conventional 2 Joint Drive Shaft
Figure 7: Conventional 2 Joint Drive Shaft
Double Cardan (CV) Drive Shaf
Figure 8: Double Cardan (CV) Drive Shaft

Note: Most drive shafts shown in photos are polished and clear coated, this finish adds $25 the cost. We only recommend the polish & clear coat for show vehicles or very dry climates.
Free Shipping - click here for more information
Questions? Give us a
call!

| Tom Wood's Custom Drive Shafts |
Copyright © 1999-2017

Disclaimer
We reserve the right to change prices, or not sell an item, due to error in pricing.

[HOME] Tom Wood's Custom Drive Shaft's [HOME]