Measuring Your Early Bronco 1966-1977 Drive Shafts

Some early Bronco’s used Borg-warner type drive shafts. These parts are obsolete and will require you to change your Transfer Case output yoke and the Differential Pinion Yoke to run 1310 series u-joints.

1310 series double cardan drive shaft with xc spline

Figure 1: 1310 series double cardan drive shaft with xc spline 

Front & Rear

The early Bronco’s will typically use 1310 series Double Cardan (C.V.) drive shafts front and rear (as in Figure 1).

Measure for length

Go to Early Bronco Drive Shaft product page.

If the vehicle is highly modified we will need more information to make sure we can build what you need. Call us for more details or read our full measuring guide here.

Proper geometry for CV Drive Shaft