Measuring Your Full Size Ford Bronco Drive Shaft

The full Size Bronco has used many different size u-joints and attachments both for the Front and Rear Drive shafts. We will need you to follow our measuring guide in order for us to build the correct drive shaft.

Front

Type B: drive shaft with a single universal joint on each end. The price will start at $219.00 for a Type B drive shaft using 1310 series u-joints.

Type B drive shaft using 1310 series u-joints

Figure 1: Type B drive shaft using 1310 series u-joints

Double Cardan C.V. (Type A: Driveshaft with two u-joints at the transfer case and a single u-joint at the differential). 

Double Cardan C.V.

Measure For Length

Spline/Slip Yoke Differences

Figure 4: Spline/Slip Yoke Differences

Rear

The rear would use the Type A Double Cardan C.V. and could possibly use flanges on one or both ends. 

A131XC shaft

A3F4F4 shaft

If the vehicle is highly Modified we will need more information to make sure we can build what you need.

Measure for u-joint dimensions

Measure for Length

Fixed Yoke to Fixed Yoke

Flanged Yoke to Flanged Yoke

Measure Flange Patterns

Proper geometry for Conventional Two Joint Drive Shaft

Proper geometry for CV Drive Shaft