32 Spline Multi-Pattern Transfer Case Flange 

32 spline output flange with 2" centering pilot and both 2.5" x 2.5" and 3" x 3" bolt threaded bolt patterns. Uses 7/16" NF threaded holes and includes 4 bolts and lock washers. It uses a 2.125" seal surface, if your current output seal is smaller than that you will need to replace your output seal. 

The great thing about that a wide variety of drive shafts can be made to fit it. With this flange is it possible to use 1310, 1330, 1350, and 1410 series drive shafts with either a single joint or a double cardan (cv), as long as the shafts are built using the correct flange. 

This will fit a wide range of transfer casesincluding the following. 

• The rear output of any 205 transfer case.
• The front output of most 205 transfer cases, excluding Chevy versions.
• The rear output of most 231 transfer cases with a Slip Yoke Eliminator.
• Atlas transfer cases.