Ford Drive Shaft Articles RSS

Some early Bronco’s used Borg-warner type drive shafts. These parts are obsolete and will require you to change your Transfer Case output yoke and the Differential Pinion Yoke to run 1310 series u-joints. 1310 series double cardan drive shaft with xc spline Figure 1: 1310 series double cardan drive shaft with xc spline    Front & Rear The early Bronco’s will typically use 1310 series Double Cardan (C.V.) drive shafts front and rear (as in Figure 1). Measure for length     Go to Early Bronco Drive Shaft product page.   If the vehicle is highly modified we will need...

Read more

Please note we do have length restrictions on building some drive shafts. Our equipment is custom length so we cannot build 2 piece drive shafts with the Carrier Bearing or Anything over 75” in length. Ford Trucks have used many different types of drive shafts and many different sizes of u-joints over the years. We will need measurements and dimensions in order to build what you need. Please follow below instructions or our Measuring Guide. Click here for the Measuring Guide F150 Front Prices for front drive shafts will start at $219.00 for a Type B drive shaft running 1310 series...

Read more

Ford Excursion’s & Expedition’s used different types of drive shafts both front and rear from the factory. We will need you to measure for dimensions so we can build the drive shaft. Depending on the type of drive shaft the vehicle is running the price on the front will vary. Front Front drive shafts will start out at $309.00 for Type B Drive shafts and $489.00 on Type A Drive Shafts. Type B Drive Shaft   Type A Drive Shaft Double Cardan C.V. (Type A: Driveshaft with two u-joints at the transfer case and a single u-joint at the differential)....

Read more

The full Size Bronco has used many different size u-joints and attachments both for the Front and Rear Drive shafts. We will need you to follow our measuring guide in order for us to build the correct drive shaft. Front Type B: drive shaft with a single universal joint on each end. The price will start at $219.00 for a Type B drive shaft using 1310 series u-joints. Type B drive shaft using 1310 series u-joints Figure 1: Type B drive shaft using 1310 series u-joints Double Cardan C.V. (Type A: Driveshaft with two u-joints at the transfer case and...

Read more